Check a supplier for problems
Results of the checks Orijin runs on a supplier used to be spread over the supplier page: banners, warning columns, the plot tables and the location quality panel. The Checks tab puts every one of them in one list.
- Open Suppliers and open a supplier.
- Choose the Checks tab. The number on the tab is how many results failed or gave a warning.
- Read the bar at the top: how many checks failed, gave a warning or were not run, and when the geolocation checks last ran for this supplier.
- Work down the sections. Each result shows its status, what the check looks for, the figure behind it (for example the measured area against the organisation’s limit) and the plot it is about. Choose the plot to open it.
- Passed results are folded away. Choose Show passed under a section to see them.
To see one plot’s results only, open the plot and choose its Checks tab.
Sections
Section titled “Sections”- Geolocation checks: problems with a plot’s boundary or GPS point, and overlaps or near-duplicates with other plots, with a link to the other plot. A plot with no boundary and no GPS point fails here.
- Location quality: each plot’s location quality score, the problems that took points off and how to fix them.
- Record completeness: the supplier’s record completeness score and what is missing from the record.
- Deforestation risk (EUDR): the screening result for each plot, or Not screened yet. Shown when your organisation screens for EUDR.
- Protected areas and built-up land: plots inside a protected area, or with a GPS point on buildings or roads.
- Buying eligibility: anything that stops purchases from the supplier: a purchase ban, a custom field value that blocks buying, a sanction, or a certification status such as Suspended.
- Area, density and yield: declared and measured areas that disagree, tree numbers or yields that are not believable for the area, and deliveries that are close to or over the supplier’s yield estimate.
Not run means nobody has checked yet. It is not a pass. For example, if the protected-area and built-up checks have never run for your organisation, every plot shows them as not run.
Run the checks again
Section titled “Run the checks again”If you can edit suppliers, the bar has two buttons:
- Run geolocation checks checks this supplier’s plots again for overlaps with every other plot, and for area, density and yield problems.
- Recalculate location quality rescores this supplier’s plots.
Both run in the background. The tab updates by itself when they finish.